60 Series Transfer Gear Selector Vibrates/Rattles

Post by **QIKAZZ** » Wed Mar 29, 2006 1:42 pm

Hey guys, I was wondering about a noise my 60 Series Transfer Gear Selector makes, it kind of rattles, seems the old owner had some kind of small weighted block on the shaft just under the know to stop it, stupid me took it off not knowing what is was, now it rattles, I have tried putting it back on but i cant seem to get it in the right spot, say for instance if its in H2, and you are cruising at 100kms, you can move the selector with one finger over to the left, the stick moves only a few mm, and just hold it over there firm with the one finger is enough to stop the rattle.

Is there some kind of adjustment for this? or is the a rubber or something worn out.

Any help would be great as it drives me crazy haha.

Cheers

Azz

Post by **Cruzer!** » Wed Mar 29, 2006 4:51 pm

mine does the same thing after i pulled it out to do all bearings.. then i must have put sometihng back wrong.. drove me insane.. i use a bungy cord to put enough pressure on it to hold it quiet.. wouldnt mind knowing how to fix it porperly tohugh

Post by **QIKAZZ** » Thu Mar 30, 2006 1:00 pm

Noone has any suggestions?

Post by **WICKED** » Thu Mar 30, 2006 1:09 pm

QIKAZZ wrote:Noone has any suggestions?

Check the round disc sittin between the two rod's on the front drive engager. mine had flat spot's on it, brasss welded in to it, was all quite after that

( bad sentence i know if i can remeber ill take a piccy for ya )

Post by **QIKAZZ** » Thu Mar 30, 2006 9:30 pm

yeah a pic would be kool because that makes no sence to me, I havent pulled it appart yet to even have a visual of what you are talking about.

Cheers

Azz

Outer Limits 4x4 Board

60 Series Transfer Gear Selector Vibrates/Rattles

60 Series Transfer Gear Selector Vibrates/Rattles

Who is online