Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

air lockers and preasure

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 709
Joined: Thu Sep 22, 2005 7:49 pm
Location: campbelltown

air lockers and preasure

Post by Mousie »

just wondering how you ajust the preasure with your air lockers

like when i put my finger over the tube and turn them off hardly any air comes out but i know they work fine.

infact so little air comes out i carnt even hear it unless your head is next to the pipes

this dosnt seem normal but then again i am not shore

any pointers in the right direction would be good

cheers
R.A.G, Ruff As Gutts 4x4 club :P
http://www.rag4x4.com/
Top
Posts: 677
Joined: Sun Feb 20, 2005 4:53 pm
Location: In them thar hills...

Post by Jeff80 »

Air lockers are actuated at about 90PSI but can work well below that. The reason you cant hear much air escaping once the locker is released is because it doest hold a lot of air in the system. It is relatively small inside the locker plumbing itself, which means it wont hold a great volume of air and doesnt need a whole lot in reserve to keep it on.

Jeff
" Some days you are the bug; some days you are the wind screen"
Top
Posts: 2492
Joined: Sun Nov 24, 2002 8:57 pm
Location: Melbourne

Post by bazzle »

75 to 105psi

Amount of air = ,, perchoof,,

Bazzle.
Top
Posts: 31
Joined: Fri Mar 03, 2006 7:51 pm
Location: qld

Post by ROCKRASH »

Gear oil being forced back up the line muffles the air release also.
Top
Posts: 848
Joined: Fri Apr 02, 2004 12:01 pm
Location: Central Victoria

Post by Patroler »

You shouldn't have to go much over 100, if you do you risk seal failure, its been done before.

You could just put a pressure gauge on the tank and see where the pump cuts out.
There are no stupid questions, but there are a LOT of inquisitive idiots
Top
Posts: 7230
Joined: Mon Oct 21, 2002 10:42 pm
Location: Brisbane

Post by MissDrew »

ARB compressors have a pressure switch that kicks in at 85psi and stops at 105psi. The locks need about 80psi (not certain on the psi) to be activated but only need about 40 or 45psi to hold in.
Top
Posts: 130
Joined: Tue Oct 14, 2003 3:55 pm
Location: Yaroomba

Post by Hardy »

I tapped into my Rangies EAS system for air supply, which can run up to 150PSI. To prevent the air-locker exploding upon activation I installed an SMC regulator, set to 90 PSI, just before the ARB solenoid.

And yeah, I get a BIG "perchoof" upon de-activation.

If you need a regulator, spend the money on a good one. The SMC jobbie was about $47. I happened to try a Super Cheap and far out, it was crap.

Hardy.
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: Bing [Bot] and 84 guests