Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

coolant coming out of resevoir

Tech Talk for Ford, Mazda, Daihatsu & Makes that currently dont have a home.

Moderator: Tiny

Post Reply
Posts: 81
Joined: Thu Jul 21, 2005 7:37 am
Location: Tennessee - USA

coolant coming out of resevoir

Post by Kickingback99 »

Does anyone know what would be causing the coolant to be pushed out of the resevoir? It is not overfilled. Happens mainly when there is more load on the engine.
Posts: 4760
Joined: Mon Dec 30, 2002 6:04 am
Location: Adelaide

Post by murcod »

You're probably not going to want to hear this:

1. Your radiator cap isn't holding pressure

or

2. You've got a blown head gasket or cracked head....
David
Posts: 81
Joined: Thu Jul 21, 2005 7:37 am
Location: Tennessee - USA

Post by Kickingback99 »

That's what i was afraid of...but if the gasket was blown, would it not have white smoke coming out of the exhaust?
Posts: 3132
Joined: Wed Sep 28, 2005 3:22 pm
Location: Newy

Post by HotFourOk »

Depends on the severity of the damage (if any)...

Go and buy a new cap first up... If it doesn't fix it... go see a mechanic, as the worse it gets, the more it will cost
[quote="RockyF70 - Coming out of the closet"]i'd be rushing out and buying an IFS rocky[/quote]
Posts: 4760
Joined: Mon Dec 30, 2002 6:04 am
Location: Adelaide

Post by murcod »

Check your exhaust pipe on a cold day and see if it's still blowing condensation once the engine is warm. Also rip all the spark plugs out and see if any are extra clean or have a green tinge to them (assuming your coolant is green!)

Another way to check is to stick an exhaust gas analyser probe into the coolant overflow and see if it registers anything (but I'm guessing you won't have one of them lying around in your shed!?)

Also you could get the coolant system pressure tested (as well as the cap) and see if it holds pressure.
David
Posts: 713
Joined: Sun Sep 11, 2005 4:54 pm
Location: Down at the pub

Post by Mudsierra »

Or u can get some one to start it up when cold while your at the end of the exhaust pipe, put ur hand in front of it when it starts up, if it feels "wet" it's a possibility it's a blown head.
"My anti-drug is 4wd"
Posts: 146
Joined: Thu Jan 12, 2006 5:47 pm
Location: Slovenia

Post by nebivedu »

MudRoza wrote:Or u can get some one to start it up when cold while your at the end of the exhaust pipe, put ur hand in front of it when it starts up, if it feels "wet" it's a possibility it's a blown head.
If this is true, then head on my feroza is blown for at least one year and 80.000km. I know my radiator cap isn't holding presure and had to fill with half of liter of water to reservoir each 20.000km. My roza has 284.000km and machine was newer open.
I do not need sex, the government fucks me every day!
Posts: 8556
Joined: Mon Jun 13, 2005 9:34 pm
Location: Sydney

Post by RockyF75 »

Also, another way to see if your head gaskets goone. pour a bit of water on/around your head when its not too hot. If you see bubbles, or puffs of smoke as I did :lol: , she's cactus ;)
60 + Turbo, 33"s :armsup:
Posts: 713
Joined: Sun Sep 11, 2005 4:54 pm
Location: Down at the pub

Post by Mudsierra »

Yeah it did work for me when i had my bomb, wet start up every morning till it carked itself. it was a head gasket that gone bad. overnite, when the motor's not running, water slowly pours into the cylinder, in the morning, start it up and where do it go? out the exhaust, the motor cause "earthquake" for a few minutes, after a while it's smooth.. yeah i've learnt a lot from that bomb and i hope not to pass it onto the roza as it's the best car i've ever got since sliced bread. ;)
"My anti-drug is 4wd"
Posts: 4760
Joined: Mon Dec 30, 2002 6:04 am
Location: Adelaide

Post by murcod »

RockyF70 wrote:Also, another way to see if your head gaskets goone. pour a bit of water on/around your head when its not too hot. If you see bubbles, or puffs of smoke as I did :lol: , she's cactus ;)
It's rare to have a head gasket let go and vent out to the atmosphere. Usually it's internal and between the cylinder / water gallery (which it would likely be in this case due to the radiator pressurising.)
David
Posts: 713
Joined: Sun Sep 11, 2005 4:54 pm
Location: Down at the pub

Post by Mudsierra »

well it happened to me too, at the very end when it wouldn't kick in.. had water shooting out between the head and block, under the manifold.
Last edited by Mudsierra on Sat Apr 22, 2006 12:44 pm, edited 1 time in total.
"My anti-drug is 4wd"
Posts: 4760
Joined: Mon Dec 30, 2002 6:04 am
Location: Adelaide

Post by murcod »

MudRoza wrote:well it happened to me mate
MudRoza wrote:it was a head gasket that gone bad. overnite, when the motor's not running, water slowly pours into the cylinder,
Ummm... you might want to read what I wrote again!?
Murcod wrote:It's rare to have a head gasket let go and vent out to the atmosphere. Usually it's internal and between the cylinder / water gallery (which it would likely be in this case due to the radiator pressurising.)
David
Posts: 146
Joined: Thu Jan 12, 2006 5:47 pm
Location: Slovenia

Post by nebivedu »

murcod wrote:
MudRoza wrote:well it happened to me mate
MudRoza wrote:it was a head gasket that gone bad. overnite, when the motor's not running, water slowly pours into the cylinder,
Ummm... you might want to read what I wrote again!?
Murcod wrote:It's rare to have a head gasket let go and vent out to the atmosphere. Usually it's internal and between the cylinder / water gallery (which it would likely be in this case due to the radiator pressurising.)
Soo, head gasket from my roza is gone bad. But roza still works fine(after 10sec eartquake in the morning).

What should i do?
Fix it or waiting that it will uses half of liter of water in les km that now. Now it consumes hakf of liter on 20.000 km.
I do not need sex, the government fucks me every day!
Posts: 81
Joined: Thu Jul 21, 2005 7:37 am
Location: Tennessee - USA

Post by Kickingback99 »

thanks for the info. will try new cap tomorrow and see how she fairs. the current cap is obviously old. Radiator has 130,000 miles on it, i am guessing and the rubber is cracked on the seals of the rad. cap. UNfortunately, local and chain part houses, here in the U.S., do not offer an oem replacement cap. anybody have any suggestions for one? GO generic or off a toyota?
Posts: 4760
Joined: Mon Dec 30, 2002 6:04 am
Location: Adelaide

Post by murcod »

An aftermarket cap should be OK.

Nebivedu it's up to you. Are you sure it's definitely the gasket as half a litre in 20000km isn't much coolant to be losing. There are additives you can put into the radiator that are supposed to fix up such leaks- could be worth a try for such a small leak? Is your radiator getting pressurised and overflowing, or is your oil a milky colour at all?
David
Posts: 146
Joined: Thu Jan 12, 2006 5:47 pm
Location: Slovenia

Post by nebivedu »

murcod wrote:An aftermarket cap should be OK.

Nebivedu it's up to you. Are you sure it's definitely the gasket as half a litre in 20000km isn't much coolant to be losing. There are additives you can put into the radiator that are supposed to fix up such leaks- could be worth a try for such a small leak? Is your radiator getting pressurised and overflowing, or is your oil a milky colour at all?
There is no water in oil or oil in the water. i change oil on every 7500km and oil is clean. Only earthquake in the morning and water leak from exaust when machine is cold. The cap on radiator is bad and there is no preasure in the radiator.

I will try to change a radiator cap today.
I do not need sex, the government fucks me every day!
Posts: 258
Joined: Wed Nov 17, 2004 7:39 am
Location: West Oz.

Post by tufferoza »

a blown HG would normaly blow small bubbles through the cooling system too, which you would see looking into the radiator when the rad cap is off and engine running.

i'ld go with murcod's 1st point of the rad cap.
pics, dribble, turbo conversion.... click [url=http://www.cardomain.com/memberpage/657917/1]here.[/url]
Posts: 8556
Joined: Mon Jun 13, 2005 9:34 pm
Location: Sydney

Post by RockyF75 »

Kickingback99 wrote:thanks for the info. will try new cap tomorrow and see how she fairs. the current cap is obviously old. Radiator has 130,000 miles on it, i am guessing and the rubber is cracked on the seals of the rad. cap. UNfortunately, local and chain part houses, here in the U.S., do not offer an oem replacement cap. anybody have any suggestions for one? GO generic or off a toyota?
You can get em here at Gas stations. I got a new one for mine just cause the old one looked yukky :D
60 + Turbo, 33"s :armsup:
Posts: 14187
Joined: Wed Apr 30, 2003 8:09 pm
Location: Trip Trip Trappin' across a bridge

Post by Goatse.AJ »

I had same problem.... bought an aftermarket radiator cap and problem solved.


But then I discovered my water pump is leaking :cry:
bru21 wrote:What happens in goat, stays in goat!
Posts: 81
Joined: Thu Jul 21, 2005 7:37 am
Location: Tennessee - USA

Post by Kickingback99 »

ok, have replaced radiator cap. still pushing coolant to overflow reservoir. Has anybody changed replaced their head gasket themselves, and if so, how difficult was it. Its on a 1990 US ROCKY, which is fuel injected. It's not my daily driver, and I'm up to trying, just want to get an idea of what has to be actually done. Have looked in factory manual, but want someone's valuable experience to go with the what the factory says.

I have to clean carbon build up out of the intake anyway, so why not.
Posts: 4760
Joined: Mon Dec 30, 2002 6:04 am
Location: Adelaide

Post by murcod »

I've done one twice on a Daihatsu CB70 ( 3 cylinder 993cc twin cam EFI turbo).

There's a fair bit of stuff that will need to be stripped off to get the head off and you'll have to make sure you get the timing belt aligned correctly when finished.

I'd advise to get new head bolts, a timing belt and the gasket all in your hands before starting. The head bolts stretch once torqued up so it's advisable to get new ones.

You should take it to a mechanic and get the coolant system pressure tested first to make sure it's definitely the problem. They will pressurise the coolant system with the engine off and that should result in coolant getting forced into one of the cylinders if the gasket is gone.

Have you checked the spark plugs at all?

Make sure you get the head machined while it's off too. That involves stripping everything off it and them making sure the mating surface is perfectly flat and square. Shouldn't cost much (last one I had done was around AUS $75.)
David
Posts: 81
Joined: Thu Jul 21, 2005 7:37 am
Location: Tennessee - USA

Post by Kickingback99 »

Thanks for the input. As for head bolts...is that something you have to get from daihatsu or what?
Posts: 4760
Joined: Mon Dec 30, 2002 6:04 am
Location: Adelaide

Post by murcod »

You should be alright reusing your own providing they haven't been reused multiple times. Ideally new ones are the go. My guess would be that they would be a Daihatsu only part?
David
Posts: 81
Joined: Thu Jul 21, 2005 7:37 am
Location: Tennessee - USA

Post by Kickingback99 »

Checked spark plugs today. They all look the same and that being normal. Noticed in my overflow that there was quite a bit of what looked like just plain dirt. Had flushed and changed coolant 5000 miles ago. Had same substance in reservoir at that time. If there was something clogging system, would this cause the problem?
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests