Hi,
My parents have a GU 2.85 tdi, we're trying to get a little more power out of it, from the search i have found suggestions that a 3" turbo back should make a difference, I'm not familiar with Diesels and raising boost etc, any info would be great, I assume the same principal would work on a diesel more air in/out +fuel + boost usually eqautes in a nice improvement.
Also does anyone know what turbo the 2.85 has ? I've been told its a t25, a nice t28 roller off a late s14 early s15 200sx would spool quicker would it not ?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
2.85tdi more power ???
Moderators: toaddog, TWISTY, V8Patrol, Moderators
a mild increase in boost will yield some results but without an intercooler you don't want to exceed about 10 - 12 psi boost. should not need to make changes to fuelling unless the pump setup is excessively lean, and it's best to have a diesel shop make the changes as just pouring in more fuel can cause very high EGT's which will melt pistons and valves, crack the turbine housing, distort the turbine, etc etc, all bad. just chopping and changing turbos is also not a great idea, the factorry turbo is good for 12+psi on these motors, it is deliberately small to bring the boost on at lower rpms. with diesels, and especially turbos, the bigger and less restricted the exhaust, the better - it is not usually necessary to run a muffler at all with a 2.5 - 3" mandrel bent pipe from turbo back will yield a noticable improvement especially right off idle.
oh to up the boost you can use an electronic boost controller, or just a manually adjusted bleed off the wastegate actuator, or adjust the actuator by shimming it away from the wastegate, or shortening the arm if it has an adjustable arm. I would not exceed 10 (maybe 12) psi peak boost on this motor.
cheers
cheers
oh to up the boost you can use an electronic boost controller, or just a manually adjusted bleed off the wastegate actuator, or adjust the actuator by shimming it away from the wastegate, or shortening the arm if it has an adjustable arm. I would not exceed 10 (maybe 12) psi peak boost on this motor.
cheers
cheers
Thanks for your reply, We're going to try the exhaust 1st, invest in a boost gauge and then play with the boost, any idea what boost they run stock ? Also we've got the GU intercooled model, any idea if front mounting these coolers works better ? Top mount seems like a bit of a heat sink to me even tho it has the factory thermo underneath.
Noticable gains were had from the snorkel !!
Noticable gains were had from the snorkel !!
Who is online
Users browsing this forum: No registered users and 2 guests