wired up my bullbar spotlights and they are really dull. I traced all the wiring and have narrowed it down to the wire from the factory highbeam loom that i am using for the switch.
If I run 12v from the battery to the switch and then the switch to the relay they work great but when i use the highbeam wire in the steering column to the switch and then the switch to the relay they are dull.
I am pulling my hair out here because I used the same highbeam wire and switch 12 months ago and they worked fine - I am at a loss :(
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
help - spotlight problem
Moderator: -Scott-
It sounds like you are running the switched wire to the wrong terminal of the relay.
You want the wire from the highbeam to go to the switch and then to 85.
A wire direct to the body from 86. (nb 85 and 86 are interchangeable).
The heavy wire from the battery goes to 30.
The heavy wire to the spotlights goes to 87.
You shouldn't have an 87A.
Jason
You want the wire from the highbeam to go to the switch and then to 85.
A wire direct to the body from 86. (nb 85 and 86 are interchangeable).
The heavy wire from the battery goes to 30.
The heavy wire to the spotlights goes to 87.
You shouldn't have an 87A.
Jason
This is not legal advice.
Who is online
Users browsing this forum: No registered users and 1 guest