Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Hilux Tailshaft Replacement

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Forum rules
Post Reply
Posts: 46
Joined: Sat Aug 27, 2005 8:47 pm
Location: Newcastle

Hilux Tailshaft Replacement

Post by deb_daz »

I have an 84 model duel cab hilux and I am looking at getting a couple of later model shafts to put on it as mine a little worse for wear.What later year model hilux shafts will fit it.Would a 91 model fit straight on including the center bearing.Would any later model shafts fit?????Any info would be greatly appreciated.
Thanks.
deb_daz
Top
Posts: 510
Joined: Fri Feb 04, 2005 7:31 am
Location: Brisbane

Post by whiteknight »

I replaced the two piece shaft and centre bearing on my 96 dual cab with a single shaft from a 4 speed 84 model, although I did have my rear axle moved back about 2 inches as well.
Top
Posts: 46
Joined: Sat Aug 27, 2005 8:47 pm
Location: Newcastle

Post by deb_daz »

Thanks for reply will take all info on board.
Cheers
Dazza
Top
Posts: 2134
Joined: Tue May 11, 2004 6:03 pm
Location: Armidale

Post by BOGAN V8 »

Better of going the one piece shaft that way the centre bearing is not in there alot better
94 HJZ 80 GXL 4 Inch lift 35s. TJM Accessories Front to back
Top
Posts: 510
Joined: Fri Feb 04, 2005 7:31 am
Location: Brisbane

Post by whiteknight »

yeah centre bearing sux big time
Top
Posts: 46
Joined: Sat Aug 27, 2005 8:47 pm
Location: Newcastle

Post by deb_daz »

Again thanks for the info.With the one piece shaft for the rear do I have to get it made up or is there one for the Hilux I have never seen one.
Cheers.
deb_daz
Top
Posts: 2134
Joined: Tue May 11, 2004 6:03 pm
Location: Armidale

Post by BOGAN V8 »

Better of to get it made up from scratch get it as thicker wall thickness as poss let pron to denting then
94 HJZ 80 GXL 4 Inch lift 35s. TJM Accessories Front to back
Top
Post Reply

Return to “Cruiser / Prado”

Who is online

Users browsing this forum: No registered users and 0 guests