Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Bent Rim Question

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 231
Joined: Wed Apr 16, 2003 9:48 am
Location: Melbourne

Bent Rim Question

Post by Andrew_C »

I have a GU that I have been having trouble with a vibration with. So far everything seems to be okay or replaced but while getting the tyres balanced we noticed I have 1 bent rim, you could see it on the balancer. So to the back door it went.
I still have a minor vibration in the car and it feels to be in the back end. It's worse through the gear stick than it is through the steering wheel.

I jacked the back tyres off the ground and in 1st gear allowed the wheels to drive while I used a ruler on a box next to the wheel to see if there was any wobble in the rims. There is a little wobble in one of them of around 3-4mm. The tyres have balanced up perfectly.

Would the distortion of the rim be enough to cause the vibration?
Top
Posts: 19062
Joined: Sat Oct 25, 2003 11:39 pm
Location: In a horse near you

Post by chimpboy »

I am not sure but is it possible that the vibration is making it look like the rim is distorted while it's turning? That is, you think you are seeing a distorted rim but you're actually seeing a good rim turn on an axle that's wobbling slightly?
This is not legal advice.
Top
Posts: 231
Joined: Wed Apr 16, 2003 9:48 am
Location: Melbourne

Post by Andrew_C »

Ill have to do a bit more wheel swapping to find out, but good question. I also thought maybe tail shaft, unis, something like that but due its hard to figure out while driving it.
Top
Posts: 11892
Joined: Tue Oct 22, 2002 9:53 am
Location: Melbourne

Contact:
Contact N*A*M

Re: Bent Rim Question

Post by N*A*M »

Andrew_C wrote:I still have a minor vibration in the car and it feels to be in the back end. It's worse through the gear stick than it is through the steering wheel.
Checked engine and gearbox mounting rubbers yet? Could be shagged.
Top
Posts: 3385
Joined: Fri Sep 17, 2004 8:26 pm
Location: Melbourne

Post by shakes »

does the car have a lift of anysort? how big? could be an issue?

check over all of your bushes, panhards, trailing arms etc

if the tyres have been balanced properly that shouldn't be the issue

Simon
Top
Posts: 6029
Joined: Tue Dec 24, 2002 9:34 pm
Location: South Australia

Re: Bent Rim Question

Post by bad_religion_au »

N*A*M wrote:
Andrew_C wrote:I still have a minor vibration in the car and it feels to be in the back end. It's worse through the gear stick than it is through the steering wheel.
Checked engine and gearbox mounting rubbers yet? Could be shagged.
classic that your replying to a bent rim question NAM...

i'll second the gearbox mounting rubbers, and also say check your driveshaft Uni joints for play/ stiffness, and test your rear pinion for play.
Spit my last breath
Top
Posts: 3385
Joined: Fri Sep 17, 2004 8:26 pm
Location: Melbourne

Post by shakes »

ohhh... when was the last time you greased all your uni's?
Top
Posts: 3825
Joined: Wed Nov 06, 2002 8:42 pm
Location: in the sky , its a bird , its a plane ! No its super MOOSE !!!

Post by moose »

its a GU !! get used to it !!! :D
most of them have a small vibration/shimmy in them !!! :armsup:
MissForbyNoob wrote:
and one day i'll just become a worthless housewife.
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 2 guests