Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
When I bought my Zook the dude who I got it off chucked in 5 15x8 steel rims, albeit pretty old and shitty, for nicks.
These were supposed to be Zook stud pattern but as it turns out aren't!
Can anyone help me with identifying what they may have come off?
Info stamped on the rim reads:
8JJx15-1505 9/95 C276 and they look just like a Sunny or similar.
Approx measurements from stud to stud is about 95mm, and stud centre to hub centre approx 85mm. Oh, and they're 5 stud with a fairly hefty offset.
bazooked wrote:with a pcd of around 170 mm ur sure thats right, works out to 6.9" and a zook pcd is 5.5"
only measured within a couple of mm's of accurate, but yeh they essentially are too big (the stud pattern radius) for the zook.
They're definately not zook, and therefore f100 either I guess.
if they were 5 stud f100 they would fit the zook...my guess is with the land rover too...if not could be newer jeep ones but i dont think the pcd on them is that big
if they were 5 stud f100 they would fit the zook...my guess is with the land rover too...if not could be newer jeep ones but i dont think the pcd on them is that big
F100 stud pattern is the same, but factory F100 rims can have a smaller centre hub, especially if they are 2WD.
if they were 5 stud f100 they would fit the zook...my guess is with the land rover too...if not could be newer jeep ones but i dont think the pcd on them is that big
F100 stud pattern is the same, but factory F100 rims can have a smaller centre hub, especially if they are 2WD.
not not wrote:Could it be possible that they are dana 44??????
Old Dana 44 as fitted to F100, F150, Bronco, Early Jeeps and scouts are 5 on 5.5"
New Dana 44's as fitted to TJ Jeeps are 5 on 4.5"
Chev Dana 44's are 6 on 5.5 (same as Toyota/Nissan etc)
Boopa wrote:
8JJx15-1505 9/95 C276 and they look just like a Sunny or similar.
Approx measurements from stud to stud is about 95mm, and stud centre to hub centre approx 85mm.
85mm centre stud to centre hub ads upto aprox 170mm bolt circle.... the only 5 stud close to that is Early Rangie, with 5 on 6.5" (aprox 165mm)
You will find they are very big wheel stud holes as well I'm guessing??
Bad JuJu wrote:Landrover is 5 on 6.5 PCD from memory.
Correct, Early Range Rover/ Land Rover is 5 on 6.5, or about 165mm, or very close to Boopa's original rough measurement of 85mm from the stud to the centre, x 2.
