thermo fan dimensions

[6.5 rangie]

Does anyone know the depth of a 16" thermo fan?
I'm limited for space (90mm) between the motor and the radiater and the EL falcon fans i have are to wide and deep, so i will have to run a 16" fan or a new radiater to suit my thermo's.

Thanks Damien

[kempster1]

http://www.daviescraig.com.au/main/fans ... tion=model

[6.5 rangie]

Bugger, looks like i'm changing my radiater.
Thanks for the info

[cbr]

Have a look at spal fans http://spalusa.com/

Here is a 16" fan that is less then 90mm in depth

http://spalusa.com/fans/automated/tech_ ... 6-2047.pdf


Chris

[Dee 4x4]

I had this same issue recently. My little 8" thermo just wasn't cutting it in the slow stuff and had to sit off centre as it was hitting the engine anyway.

I upgraded to a 12" thermo which fits the Sierra radiator absolutely perfectly. Since there was never going to be enough room between the radiator and the engine for the 12", I simple spaced the radiator out from it's mounts so it was now about 5mm from the engine (fan belt) and I placed the larger and subsequently deeper thermo fan in front of the radiator so it blows through rather than pulls through.

The setup worked flawlessly on my first outing. Unfortunately, my engine died for other reasons and has now been in the shop for two weeks...

[6.5 rangie]

I could move the radiater closer to the engine and fit a fan in front providing that it will work just as good.
thanks for the idea

[LuxyBoy]

I simple spaced the radiator out from it's mounts so it was now about 5mm from the engine (fan belt) and I placed the larger and subsequently deeper thermo fan in front of the radiator so it blows through rather than pulls through.

Sounds like fun for belt changes or crank case cover removal
You don't get heat saturation when you stop and turn the engine off as the radiator is so close to the engine

[cloughy]

Does anyone know the depth of a 16" thermo fan?
I'm limited for space (90mm) between the motor and the radiater and the EL falcon fans i have are to wide and deep, so i will have to run a 16" fan or a new radiater to suit my thermo's.

Thanks Damien

Same reason i didn't end up using them, why not 2 12"s better than one, covers more area and if 1 dies there is still 1 running, thermo's are better off on the backside of your radiator, more effetive and dont get covered in as much grit

Funny thing about davies craig 12" compared to 10", the 12" is only 1" larger!!

[6.5 rangie]

will measure it up and see if it'll fit

[Dee 4x4]

Sounds like fun for belt changes or crank case cover removal
You don't get heat saturation when you stop and turn the engine off as the radiator is so close to the engine

Heh nah it's fine. It's the bolt that holds the main pully wheel which is the closest point to the radiator. The actual engine would be a good 100mm from the radiator. It's a 4AGE mounted N/S so heat coming off the front of the engine isn't really an issue and there's only one belt which looks like possible the easiest belt to replace in any car ever.

From top view.

|||||||||||||||||||||
|||||||||||||||||||||< block
--|-------------|----
[|||]====[|||||||]< pully wheel things

----------------------
----------------------< radiator
|______________|< big ass fan

Plenty of room to change the belt and enough room between the grill and the radiator for a nice big thermo. The thing roars where its spinning, and on the first trip out I punished the car and couldn't get the temp guage to budge.