I chipped the surface on my swivel hub yesterday and was wondering how to repair it so the seal won't leak. The chips about 1mm deep and about 2-3mm round.
Should i try weld it and grind/polish it back up or could i try fill it with some arrildite or something.
Any suggestions would be great as i've just had them rotated and about to fit them up.
Thanks Damien
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Chipped swivel hub
Moderator: Micka
I have used that but it falls apart too easily without something to stick to, devcon is a 2 part epoxy that dries hard and can be drilled and tapped if needed, try an engineering supply or bearing shop for this or something similar.
Saddle up tonto, its the not so loanrangie! . 98 TDI DISCO lightly modded with more to come.
Who is online
Users browsing this forum: No registered users and 2 guests