Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
notice a few days ago that low beam on the drivers side is not working AGAIN . thats 3 times with 3 different globes in 5 months though high beam and passenger side work without a problem. each time its been a case of low beam working for 2 months then it goes out. cant be wiring then the lights would never work, cant be globes as filaments are all intact. can anyone shed any light on the problem?
mightyjimny wrote:notice a few days ago that low beam on the drivers side is not working AGAIN . thats 3 times with 3 different globes in 5 months though high beam and passenger side work without a problem. each time its been a case of low beam working for 2 months then it goes out. cant be wiring then the lights would never work, cant be globes as filaments are all intact. can anyone shed any light on the problem?
If you try that globe in another unit, does it work propereley.
If so, then a loose joint or cracked wire could be the issue.
But if it is continually blowing only the low beam, then I'm guessing it is getting too much power for some reason.
My money would be on a dicky earth, that works partially, or only when it wants to.
There is an auto elec section, full of whizz kids and tech heads that may be more help.
christover
4WD SUZUKI CLUB VICTORIA
http://www.vic.suzuki4wd.com/forum/
Had Same problem on high beam and driving lights on the Feroza for a while. Found that coz i was buying cheapy globes from servoes to replace dead ones while on the road, they just didn't last. Bought Narva or other quality globes and problem gone
have only ever bought the one pair. other pair were bought by a smash repairer after i got some panel beating done and he thought he busted the globe (but hadnt).
i reckon theyre awesome. when i get around to it i might buy some of the more cheaper popular ones and see how they compare.
. thats 3 times with 3 different globes in 5 months though high beam and passenger side work without a problem. each time its been a case of low beam working for 2 months then it goes out. cant be wiring then the lights would never work, cant be globes as filaments are all intact. can anyone shed any light 
on the problem?
