advance adapter & marlin instructions

Post by **4sum4** » Thu Jun 15, 2006 7:46 pm

Advance adapters instructions are pretty shiat,Can you use the same principles as Marlin`s and it mentions in Advance adaprters that you need to cut part of the shift rod off is this necessary?

Post by **Frankenyota** » Thu Jun 15, 2006 8:51 pm

Did dual case install with two top shift cases and didn't have to cut shift rods, best to see how far the rod comes out then check it against the other case.
However i did have to grind the input shaft so it would fit up to the adapter. Found marlins instructions heaps better.

cheers Matt

Post by **spazbot** » Thu Jun 15, 2006 9:42 pm

Yeah i used marlins for my install and its all the same basically
Also found if you got a 12mm drill run it through the adapter in the hole for the front shift rod, as both of the castings ive worked with were very tight and it helps shifting a lil bit.

I also run the 2nd ball from the front cast behind the spring for the front shift to give it some extra locking force as i found i likeed to jump out of gear into netural on down hill runs.

Post by **4sum4** » Fri Jun 16, 2006 5:49 pm

how much extra oil do i need

Post by **4sum4** » Sat Jun 17, 2006 3:55 pm

so I`m left with a speed-o bushing WTF is that for

Post by **spazbot** » Sat Jun 17, 2006 4:16 pm

that the tapered looking bolt thing with a hole in the middle ?

if so mines still in my box and ive never found a use for it

Post by **Frankenyota** » Sat Jun 17, 2006 5:21 pm

That's what i would like to know?

Outer Limits 4x4 Board

advance adapter & marlin instructions

advance adapter & marlin instructions

Who is online