Engine Mounts, How hard to replace

[MyGQ]

Ok well 16 years of use has finally taken its toll on my engine mounts, the driver side rubber mount is as the french say, Le Farked.

I got myself some new ones today and i am wondering how hard a job it is to replace the little buggars. It is as simple as jacking up the engine slightly, unbolting the old one and putting the new one in?

[Daisy]

Correct..

simple as jacking up one side and unbolting and puttin new one in.

Might be a little fidgety but you'll get it in.

TOM

[jono]

We did the left hand one in camp in about 3/4's hour in and out with the help of one of those air bags that run of your exhaust
Jono

[hottiemonster]

i did mine when i did the engine swap and it couldnt have been easier

[Beastmavster]

You loosen off both (but only unbolt completely the one you want to remove), jack up motor, replace......


Note the following:


The other one is probably "le farked" or near "le farked" too.
Aftermarket ones often are a pain to fit and not quiiiiiiiiiiiiite identical


Have fun.