Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

SQUEALING

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Post Reply
Posts: 55
Joined: Thu Aug 11, 2005 9:30 pm
Location: Greensborough, Melbourne

SQUEALING

Post by ike181 »

Ey guys, I'v got a 1980 MQ diesel and every time I got to start her up it makes a squealing noise…… if u stand at the fount of the car it’s coming from the left side. I don’t know much about diesels and I wouldn’t have a clue wat it is :roll: . Can eny1 help ? :?: :?: :?:

Thanks Alex
Posts: 192
Joined: Tue Dec 20, 2005 1:37 pm
Location: Brisbane

Post by spannercrab »

Slipping belt on startup - then belt warms up and it goes away?

If it's constant it's possible it's a bearing in the alt / ac compressor ... or even a rock or dirt stuck behind a pulley somewhere ....
If it's worth doing - it's worth doing to excess ...
Posts: 55
Joined: Thu Aug 11, 2005 9:30 pm
Location: Greensborough, Melbourne

Post by ike181 »

it looks like its coming from down the bottom. There is a lil thing that has a rod connected to it and when u turn the power on the rod moves and makes the noise, it makes it when the glow plugs are heading up. hahah if u can understand that your doing well......
Posts: 192
Joined: Tue Dec 20, 2005 1:37 pm
Location: Brisbane

Post by spannercrab »

You're talking about the fuel control motor assembly? Bolted to the inlet manifold, has a rod that moves back and forth which is connected to the back of the fuel pump (which has 6 pipes coming from the top).

Probably a dry bearing / bushing in the motor assembly itself - might just be dirt, it's a bit fiddly but you can dismantly the whole assembly, clean it out and grease it up again (this is just short term as these types of motors generally use sintered bronze bushings rather than bearings - once they are dry it's reasonably difficult to re-lube them).

There is a slight possibility the gear set may have all it's lube dried up through age or water ingress - so in this case, just a few dobs of white marine grease in the assembly might cure it.

In any case - it's a fiddly job and it might just be easier to grab another one from the wreckers - but if the noise is that bad, the problem will more than likely be a fairly obvious one.
If it's worth doing - it's worth doing to excess ...
Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests