Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

replacing td42 injector pump gasket?

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Forum rules
Post Reply
Posts: 65
Joined: Thu Jan 26, 2006 7:45 pm
Location: Calliope QLD

replacing td42 injector pump gasket?

Post by scmick »

Howdy guys, im about to replace the top gasket on my injector pump, just asking if there is anything i need to know before i do so, ie, if anything will jump out at me when i pull the top off?, :?: any help would be appreciated, cheers
Twin locked 75 cruiser project
Top
Posts: 1251
Joined: Sun Jan 02, 2005 11:36 am
Location: Nth brizzy

Post by not not »

Your best idea is to get a diesel pump and injection shop to do it for you. If you dont have much idea on the subject then best leave it to the pros. As they are very expensive items if failure occurs. Cheers jamie
Twenty4-7 Rock Racing
#247
http://www.mickeythompsontires.com.au/index.htm
Top
Posts: 91
Joined: Wed Dec 15, 2004 8:35 pm
Location: brisbane

Post by matty b »

jamies right
but if you are going to attempt this remeber if you get even the smallest bit of dirt or grit in there your going to cause yourself all sorts of dramas too
Top
Posts: 65
Joined: Thu Jan 26, 2006 7:45 pm
Location: Calliope QLD

Post by scmick »

Iv done it this morning, easy to do, took about an hour then had to bleed the whole system and NO LEAKS, made sure it was clean as before i started so hopefully no dirt in there, all is good, be a good excuse to drop in a injected 308 if it shits itself :lol:
Twin locked 75 cruiser project
Top
Posts: 303
Joined: Wed Nov 24, 2004 8:25 pm
Location: gold coast

Post by mavzilla »

did you put the shaft o rings in as well when ya had the top off
if not they will be as shagged as your top plate seal and leak soon
wish list (lockers,lift,endless air,winch,bar,spotties,35s,paint job,turbo,18yrs old hottie
Top
Posts: 65
Joined: Thu Jan 26, 2006 7:45 pm
Location: Calliope QLD

Post by scmick »

mavzilla wrote:did you put the shaft o rings in as well when ya had the top off
if not they will be as shagged as your top plate seal and leak soon
Yeh mate, they came with the top gasket, had to replace the copper washers on the fuel line in also
Twin locked 75 cruiser project
Top
Post Reply

Return to “Nissan”

Who is online

Users browsing this forum: No registered users and 4 guests