Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Hi Beam probs

For all things Electrical.

Moderator: -Scott-

Post Reply
Posts: 33
Joined: Sat Jun 17, 2006 7:20 am
Location: Gordon Vic

Hi Beam probs

Post by stevepet »

Need some advice. For some reason right hand headlight is not getting power on high beam circuit. The globe is fine have checked circuit and there is no juice in high beam wires at all. My question is it possible to tap into power at left headlight and run a wire to right headlight or is it better to tap into wires at high beam switch?

Thanks :armsup:
Posts: 14209
Joined: Sun Jan 11, 2004 11:36 am
Location: Adelaide

Post by -Scott- »

While you're under the bonnet running new wires, add a relay and heavy duty wiring loom. ;)

Scott
Posts: 558
Joined: Sat Dec 11, 2004 4:38 pm
Location: Gold Coast

Post by drivesafe »

Hi stevepet, depending the type of vehicle you have and whether it has headlight relays or not.

In many vehicles, the most common cause of problems in vehicles without headlight relays, is part of the headlight switch gets burnt out and just running a wire from one headlight to the other could overload the good light’s circuit which could have a number of adverse results, like both lights now being dull and / or the fuse being blown, or the headlight switch being overloaded further, causing it to burning out completely

You are far better off trying to find the problem and fixing it or, as Scott suggested, put in a headlight wiring upgrade loom.

Being honest, I produce headlight wiring upgrade kits, so I have a barrow to push but having said that, there are a number of advantages to doing a headlight wiring upgrade.

An upgrade can not only get around the problem of only one light working and / or have dull lights but as it removes the load off the existing headlight switch, which usually means that you will never have to replace the switch again and a wiring upgrade is usually heaps cheaper than the cost of replacing a headlight switch.

Plus, a headlight wiring upgrade usually makes your existing headlights brighter than they were but if in the future you decide you want to fit more powerful globes to brighten up your headlights even further, you already have the heavier wiring in place so you will get the most advantage out of the new globes.

Cheers
2007 TDV8 Range Rover Lux
2009 2.7 Discovery 4
Posts: 94
Joined: Fri Sep 16, 2005 5:11 pm
Location: S.E.Qld.

Post by Gruntahunta »

Listen to the man, he knows what he is talking about, very wise move!...........Pete!! ;)
Artificial Intelligence is no match for Natural Stupidity!
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest