clutch install

[benjamin78au]

okay pll i need help

I have just put new clutch on the fly wheel , it is all alligned, now how the heck do i put the gear box in , we get it up but can get it to slide in to place, we get everything looking right except for the last 1 or 2 cm .


The springs on the pressure plate go towards the gearbox right >???? i think so as that what i rememerb and the clutch cover fits over fine.


We put th etail of gear box up and then the front, so getting it in to the tunnel not the problem , have had it in neutral , adn turned motor by hand , even put it in gear and turn jack shaft, we feel it line up on the spline, and it wont slip those centimeters it probly 10 mm .
we can get 1 bolt in , just not the 2nd thru to 4th .

ideas


bj

[john1974]

hmm thats weird, mine went on almost all the way, then I shaked, and wiggled it on the rest of the way. the last cm I used the bolts to tighten her up. Make sure everything is aligned proper, and other than that I dont know.

[smiley_smoke]

i think there is a post on this previously.. something about grinding out a 5mm V off the crossmember.. ?

ill do a search see what i can find