Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
4.6 motor on a 6000 warn
Moderators: toaddog, TWISTY, V8Patrol, Moderators
4.6 motor on a 6000 warn
as it says above i can get hold of a 4.6 for the 6000warn, i might wire in a couple of extra solenoids aswell, will i blow anything up with the extra grunt?, also runnin 8mm dynemma.
buggy time............
Them major difference between these and larger winches in the gearing ratio and size which essentially means it will pull faster but reach it's stall load earlier or phyisically break before it reaches stall. Is unlikely to damage it at lower recovery load. That said, I believe current model come with this motor so should be OK.
As long as it has 8mm or larger cable that should not be problem either.
I'm no expert, just my opinion.
As long as it has 8mm or larger cable that should not be problem either.
I'm no expert, just my opinion.
KRiS
Who is online
Users browsing this forum: No registered users and 3 guests