I went up to Mt Dissapointment on Saturday and destroyed my rear diff in my '89 Rangie.
I'm looking at buying a detroit locker in a Rangie diff housing. The guy has been running JMac 24 spline axles.
So the question is can i run standard disco 24 spline axles? Is the hub the same as the origional 10 spline that would have origionaly been in the diff.
I know the strength may be an issue, but i'm only running 32" muddies.
Thanks
Alex
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
24 splines into Rangie Diff
Moderator: Micka
I believe you will need to use the 24spline stub axle, hub and bearings. That is what I did anyway 
Should cost ~$220 for the stub axles, hubs and axles.
LukeV
Should cost ~$220 for the stub axles, hubs and axles.
LukeV
'88 Rangie, 3.9i, Bilstein Shocks and RS Springs, ARB Lockers F&R, 24spline rear axles, Flares, [url=http://users.on.net/~vethaak/Projects.htm]Custom centre console and cargo shelves[/url]
Hi
we put a Jac Mac Locker in Disco Dave rear and used the 24 spline later model Disco axles, bolted straight in. So far so good.
24 spline axles should fit RRs rear housing although I'm not sure if you will need the D1 or D2 hubs too - I think there were some slight differences in the hub offsets though I don't think this affects the axles. Anyhow, if needed, D1 D2 hubs are cheap and fit straight on - same bearings.
we put a Jac Mac Locker in Disco Dave rear and used the 24 spline later model Disco axles, bolted straight in. So far so good.
24 spline axles should fit RRs rear housing although I'm not sure if you will need the D1 or D2 hubs too - I think there were some slight differences in the hub offsets though I don't think this affects the axles. Anyhow, if needed, D1 D2 hubs are cheap and fit straight on - same bearings.
Nice gq swb ute chop with a huffer for the good times
Who is online
Users browsing this forum: No registered users and 5 guests