how waterproof are HID balasts? any particular care in how they are positioned. just got a set of 50W and going to mount them.
cheers
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
HID balasts are they waterproof?
Moderators: toaddog, TWISTY, V8Patrol, Moderators
I forget if the 50watters are IP rated. Should be 'moisture' proof at least.
If you were to run a bead of silicon around both the 12v grommet and the high tension grommet, as well as another bead around the base of the ballast, I rekcon you'd make it that much better.
I havent bothered doing the above yet to any of mine. I really should. One particular pair I've dunked (el-cheapo's 'made in china' ballasts) a few times now, doing silly river crossings. So far they have survived and still work fine.
If you were to run a bead of silicon around both the 12v grommet and the high tension grommet, as well as another bead around the base of the ballast, I rekcon you'd make it that much better.
I havent bothered doing the above yet to any of mine. I really should. One particular pair I've dunked (el-cheapo's 'made in china' ballasts) a few times now, doing silly river crossings. So far they have survived and still work fine.
Bushies: http://www.angelfire.com/on4/bushy5560/ http://www.angelfire.com/on4/bushy5561/
Lightforce HID conversion stuff: http://www.angelfire.com/on4/bushy5551/
Lightforce HID conversion stuff: http://www.angelfire.com/on4/bushy5551/
If they are xtec brand, then they are waterproof to about 1.5m and should withstand avge engine bay temps ie 80+ deg. I have had them sitting under water in the outback challenge for about 1 1/2 hrs and there were no issues with them, but I agree with bushy that it would be advisable to run a bead of silicone around them. I have mounted the ballasts exposed on the front of bullbars, and next to turbo manifolds without issues (this was just to test the product befor I sell it) but would advise that you mont them where they are not visible so people don't see you have hids and steel them.
Hope this helps
Hope this helps
Road Ranger
Who is online
Users browsing this forum: No registered users and 48 guests