Hey all
I'm not the most mechanically minded person and would appreciate some feedback on my clutch.
I drive a '93 Hilux. Lately I've noticed that my clutch has been deteriorating. Sometimes it only seems to have about an inch of "tension" when taking your foot off it (doesn't cause a stall but you need to put the revs on earlier), more and more when I go to take off and put it in 1st I have to depress the clutch then try again to get it to actually go into gear and occasionally there is a bit of grinding when putting it into reverse.
Does this sound like my clutch is on its way out or could it just be that the clutch needs to be bled? It is hydraulic.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Hilux clutch - help please
Moderators: toaddog, Elmo, DUDELUX
if your having to pump the clutch pedal it sounds like either the master or slave cylinder is leaking
check the resivoir fluid level 1st
if low check the slave cylinder on the g box, peel the rubber boot off n see if any fluid runs out ,if yes the slave cyl is shagged and needs replacing
if not check either side ofthe firewall for fluid stains around the master cyl / resivoir area if yes replace master cyl
check the resivoir fluid level 1st
if low check the slave cylinder on the g box, peel the rubber boot off n see if any fluid runs out ,if yes the slave cyl is shagged and needs replacing
if not check either side ofthe firewall for fluid stains around the master cyl / resivoir area if yes replace master cyl
Who is online
Users browsing this forum: No registered users and 10 guests