I've bought a orginal tachometer for my MQ. But when I installed it it didn't work. The wiring was already there so it was plug and play.
Do I need more parts to make it work? Or is it just broken. The Nissan manual wiring diahgram says that there also is a "tachometer-resistor". Does my '84 MQ L28 without a tachometer have this resistor?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
MQ tachometer L28
MQ tachometer L28
Patrol 2.8 '84, twin carburators, Z-car header, 280ZX cam, SPOA, ARB lockers f+r, Ramsey winch, 33" Maxxis Mudders and some rust....
L28 tacho is 3 wires.
2 wires go through the resister ( small silver box ) that screws on the back of the instument cluster, they then plug into the nissan wiring loom.
The other wire is the signal feed wire.
if plugs into the negative side of the ignition coil itelf.
if you want to test your tacho just sit it in the engine bay and grab the wire that runs down the to coil ( i think its a black one ) and put it on the negative on the coil and see what happens.... then plug one wire on ur positive on ur batter and the other on ur negative, with all 3 wires giving you power, earth and signal your tacho should work just sitting it in the engine bay.... if it all works then u plug it in and it does, you have a problem with the wiring....
with which case i have just told u how to wire it, so just run an ignition power, and earth and a cable through the dash and firewall out to the negative on the coil.....
problem solved.
screwy
2 wires go through the resister ( small silver box ) that screws on the back of the instument cluster, they then plug into the nissan wiring loom.
The other wire is the signal feed wire.
if plugs into the negative side of the ignition coil itelf.
if you want to test your tacho just sit it in the engine bay and grab the wire that runs down the to coil ( i think its a black one ) and put it on the negative on the coil and see what happens.... then plug one wire on ur positive on ur batter and the other on ur negative, with all 3 wires giving you power, earth and signal your tacho should work just sitting it in the engine bay.... if it all works then u plug it in and it does, you have a problem with the wiring....
with which case i have just told u how to wire it, so just run an ignition power, and earth and a cable through the dash and firewall out to the negative on the coil.....
problem solved.
screwy
TUFF TRUCK TEAM OPPOSITE LOCK Proudly Sponsored By:
Opposite Lock Narellan, Lightforce Australia, Offroad Systems, Judd Panels, Townsend Signs, RDG Engineering, Central Safety Workwear
Opposite Lock Narellan, Lightforce Australia, Offroad Systems, Judd Panels, Townsend Signs, RDG Engineering, Central Safety Workwear
Who is online
Users browsing this forum: No registered users and 2 guests