just trying to find somewhere to purachase a 3 inch grommet for where my snorkle enters the front quarter panel. Tried Clark Rubber and they need to make custom one and it was going to cost me $40-. Anyone have any ideas or other solutions?
cheers
Geoff
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
3 inch grommet for snorkle where can i get one?
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Clark Rubber sells rubber strip that covers edges in car panel work.
It may be called windscreen edging?? I can post a pic if you like.
I has a hollow section in the centre where you push it onto the exposed edge, and the outer rubber sections cover the panel. You can get it in about 5mm, 10mm or 20mm depths.. depending on how neat you were
I bought it when i did my snorkel to finish off where the last bend entered the quarter panel.
I pushed it on, cut it to size, then removed it and used black silastic inside the rubber to hold it in place.
Its better than cutting the tube as mentioned, because the edges are straight and not rounded, so it gives a very good finish.
It may be called windscreen edging?? I can post a pic if you like.
I has a hollow section in the centre where you push it onto the exposed edge, and the outer rubber sections cover the panel. You can get it in about 5mm, 10mm or 20mm depths.. depending on how neat you were
I bought it when i did my snorkel to finish off where the last bend entered the quarter panel.
I pushed it on, cut it to size, then removed it and used black silastic inside the rubber to hold it in place.
Its better than cutting the tube as mentioned, because the edges are straight and not rounded, so it gives a very good finish.
[quote="RockyF70 - Coming out of the closet"]i'd be rushing out and buying an IFS rocky[/quote]
Who is online
Users browsing this forum: No registered users and 137 guests