My mounts are the generic ones where the upper plate and lower plate link together on one side (upper has a wide t shaped tab that goes through a square tab on the lower) and the rubber sits between them. The seat belt idea wont work very well on these mounts. What i have done is using high impact Polly (industrial cable tape) shim the top side of the upper plate where it goes through the lower plate so there is no room for upwards movement . Meaning that when the motor torques up rather then trying to lift the mount the force is transferred to the other mount in compression.
HOPE YOU CAN UNDER STAND THAT!!!
Can anyone see a problem with this?
Cheers
SASS
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
chaining down my engine!!!!
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Who is online
Users browsing this forum: No registered users and 2 guests