Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
After having to weld an extra gusset to the inside of my cab for engineer's the back panel still on its bowed out a touch
to "pull" it back in, I know a mix of heating it up and cooling it down quickly will work. just unsure of should I be applying heat and cooling from the inside or outside for best results?
I'm gunna have a couple of practice shot's but any hints or tips from people?
Get a sponge or cloth and a bucket of water. Apply heat with an oxy to small sections of the the high spots (until almost cherry red) then hit with sponge to shrink. work in circles around over the area you want to shrink.
