clutch bleeding problems...HELP!!!!!

Post by **Roctoy** » Mon Nov 20, 2006 9:06 pm

Now i have a 3rd car out of action, the one i thought was the reliable one.

Today I replaced the rubber hose that goes between the body and the slave cylinder on my GQ 4.2 petrol. No matter how many bottles of brake fluid i pump through the system i still can't get the clutch lever on the side of the gearbox to move more than 10mm when the pedal is pushed right in. There doesn't seem to be any air in the sytem and the master and slave cylinders seals are not leaking.

This is doing my head in.
Can anyone help me?

Chris

Post by **ozy1** » Mon Nov 20, 2006 9:13 pm

i know in the diesel, there is a line in the passenger side of the engine bay near the firewall, it also connect to the clutch, i needed to bleed this as well, once it was done pedal was great, not sure if the petrols had this thou, but worth a look

it looks just like a square block with a bleed nipple on it,

Post by **Roctoy** » Mon Nov 20, 2006 9:20 pm

yep this setup is the same except the block has an extended pipe that runs to a bleed nipple at the back of the engine bay, we have bled from the top then the bottom, and repeated this for nearly 2 bottle of fluid.

Post by **ozy1** » Tue Nov 21, 2006 6:25 pm

so you have bled them at the master, the slave and at the block (thing)????????

Post by **Roctoy** » Tue Nov 21, 2006 7:02 pm

ozy1 wrote:so you have bled them at the master, the slave and at the block (thing)????????

done all i can. Car was towed to a brake & clutch place, they couldn't bleed it any better than me so are in the middle of a master cyl overhaul.

Post by **RUFF** » Tue Nov 21, 2006 7:20 pm

Sounds like it has a broken or collapsed return spring in the Clutch Master Cyl.

Post by **Roctoy** » Thu Nov 23, 2006 10:35 am

it was something internally in the master cylinder, on visual inspection it all seemed fine, but it has been honed out and re sealed and now it all works, thanks to Aussie Brake & Clutch, Kourtum Drive Burleigh Heads.

Post by **lowexf** » Thu Nov 23, 2006 9:18 pm

I had the same trouble with mine, the piston moved in the master cylinder when i put a new slave on and it just didn't want to work in its new spot. Tried bleeding with vacuum, pressure bleeding at the reservoir, everything, in the end I bought a new master cylinder and it fixed it straight away..

Outer Limits 4x4 Board

clutch bleeding problems...HELP!!!!!

clutch bleeding problems...HELP!!!!!

Who is online