B&M launch control solinoid

[professor]

has anyone had experience with the solinoid before?


I want to use it to stop the brake from working not to lock and hold as it was inteneded. Do I have to change the in and out lines over so it will work? I ask this as im not sure that the solinoid works in both directions.(does it bypass to the brake when it is activated.)

Chad

[chunderlicious]

launch control solenoid..... that stops the wheels spinning when taking off. B&M (i think) make a line lock kit....disconnects the rears to spin while the front is clamped

[NCpaj]

ha sounds complicated, just get a pajero then it is impossible to spin any wheels

[professor]

ha sounds complicated, just get a pajero then it is impossible to spin any wheels

I thought that was hilux's

The solinoid is as it says on the packaging "Launch control"

it is designed to operate the brakes and engage the solinoid so you dont have to man the break for take off. I want to put it in line to stop the front brakes working for front dig.(i dont want pressure going to the front brakes) if i set it up the same as intended im thinking that it will not stop fluid going to the brakes as it has an in and an out labled on the unit.

Chad

[chunderlicious]

yeah that will work perfect. i think it is the line lock kit though because the launch control is traction control.....sounds cool when normal cars use them....makes a weird noise that you cant quite figure out what it is.

[professor]

yeah that will work perfect. i think it is the line lock kit though because the launch control is traction control.....sounds cool when normal cars use them....makes a weird noise that you cant quite figure out what it is.

Launch control part number 46075

this is what i brought

http://www.rocketindustries.com.au/desc ... no=BM46075

Chad

[pcman]

just fit it as directions say

press button, apply brakes

no brakes

launch control is cause you use them to lock the brakes so you can stall it up then drop the clutch hence dont need 3 feet

[CRUSHU]

In our drag cars, we use a hydraulic tap in the line to the rear brakes, that way we if we close the tap (1/4 turn) without the brakes applied, and braking force we use is only directed to the front tyres, good for car control during the burnout. once the burnout is done, we open the tap, and 4 wheel brakes are restored.
If we close the tap with the brakes applied, it will keep the pressure on the rear brakes, even if you get out of the car. we sometimes use it as the handbrake whilst on the tow truck.
Only a few bucks from your local pirtek....

[professor]

just fit it as directions say

press button, apply brakes

no brakes

launch control is cause you use them to lock the brakes so you can stall it up then drop the clutch hence dont need 3 feet

so it will stop the fluid in both directions???? both applying brakes with solinoid already on (Brake stops working) and holding brakes on then turning solinoid on so brake stay on without the foot on the pedal.

Chad

[ozrunner]

Yep.

If you plumb it into your front brake line if you switch it on before applying brakes you will have no front brakes as it won't let fluid past etc.

Turn it on with foot pressure on the brakes and it will hold the fronts on. Not recommended for use longer than 1 minute.