wide track discs

Post by **toyrex** » Tue Dec 12, 2006 8:13 pm

I have be casting nodular iron flywheels for a while now
My question is, is there any interest if I have some disc rotors cast with extra offset for Hilux wide axle conversions, These will be made to eliminate the use of hub spacers the cost off these will depend on how many I can pre sell and minimum amount the foundry will cast
The more I order the cheaper they will be

Adrian

Post by **Tomolux** » Tue Dec 12, 2006 9:09 pm

hell yeah, so long as they are the proper dia. & vented, slotted wouldn't hurt

. to suit the IFS calipers

and of course cheaper than buying spacers.

Post by **STUMPY** » Tue Dec 12, 2006 9:50 pm

I would be very interested.

Post by **tuf045** » Wed Dec 13, 2006 6:58 am

STUMPY wrote:I would be very interested.

x2 depending on price.

Post by **Sic Lux** » Wed Dec 13, 2006 7:36 am

Shit yeah know of a few that would be.

Post by **TOYTRUK** » Wed Dec 13, 2006 1:22 pm

if you could cast spacers at a good price i think it would be more practical .its only a hundred bucks for lc vented rotors and you can get em anywhere.
thats just my 2c .no offence mate.

Post by **4sum4** » Wed Dec 13, 2006 3:56 pm

TOYTRUK wrote:if you could cast spacers at a good price i think it would be more practical .its only a hundred bucks for lc vented rotors and you can get em anywhere.
thats just my 2c .no offence mate.

more than a hundred each and then you got to get the spacer kit and calipers

Post by **Frankenyota** » Wed Dec 13, 2006 9:46 pm

Would be interested, depending on price.
Would they make the front as wide as a IFS rear axle?
Vented?

Post by **toyrex** » Thu Dec 14, 2006 5:52 pm

TOYTRUK wrote:if you could cast spacers at a good price i think it would be more practical .its only a hundred bucks for lc vented rotors and you can get em anywhere.
thats just my 2c .no offence mate.

My idea of making the discs is to eliminate the use of illegal spacers and having to get a engineer to sign them of

Adrian

Post by **toyrex** » Thu Dec 14, 2006 6:02 pm

Frankenyota wrote:Would be interested, depending on price.
Would they make the front as wide as a IFS rear axle?
Vented?

The discs are to be used with the IFS hubs on a live axle set up
I think this widens the track about 35mm each side
At this time I am feeling out if there is any interest in them
Cost will depend on how many I have cast and machined
on a rough quote I have to cast 100 for any sort of realistic price

Adrian

Post by **TOYTRUK** » Mon Dec 18, 2006 8:25 pm

sounds cool ,would probably consider selling my spacers if the price was ok.like you said it saves engineering hassles.i think my spacers were about 250.00. cant remember now.

Outer Limits 4x4 Board

wide track discs

wide track discs

interested

Who is online