does anyone know where there is a step by step guide to putting a swivel hub kit and new wheel bearings through the front of a GQ?
cheers
OONDY
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Swivel hub re-build
Swivel/hub rebuild
I can't remember who makes the manual, but you can get them for under $50 at REPCO...
If you need any advice/help just PM me.
I did mine last week so its still fresh in my mind.
The hardest parts:
-Ripping out the axle seal (Eventually hacked the old one with a chisel, broke it in 1/2 then ripped it out)
-Removing the old kingpin bearings (Angle grinder!!)
-Getting the amount of shims just right on the kingpins.
-Getting everything back in order, (Take note of the oreintation of thrust washers etc!)
Good luck with it!
If you need any advice/help just PM me.
I did mine last week so its still fresh in my mind.
The hardest parts:
-Ripping out the axle seal (Eventually hacked the old one with a chisel, broke it in 1/2 then ripped it out)
-Removing the old kingpin bearings (Angle grinder!!)
-Getting the amount of shims just right on the kingpins.
-Getting everything back in order, (Take note of the oreintation of thrust washers etc!)
Good luck with it!
Don't expect to see my recipe, until I receive my cheque and collection fee
Swivel hub
http://picasaweb.google.com/internetweb ... ebuildPics
Here is a pic of the kingpin bearings, don't be afraid to use a little force on these stubborn bastards. Try breaking the bearing case off completely, cutting the rubber seal off then hitting the bearing with a rift or chisel. If all else fails, ANGLE GRINDER.
With the shims, if you are replacing these bearings, they will be tighter than the old bearings. Try at least one shim top and bottom, you should be able to swivel the knuckle on the steering joint with no more than 2.5kg of force once you have the kingpin bearings tightened down (on top and bottom of the knuckle). Anymore and you could risk cracking the bearing when under extreme conditions.
(How do I upload photos directly to the forum??? pm! pls.)
Here is a pic of the kingpin bearings, don't be afraid to use a little force on these stubborn bastards. Try breaking the bearing case off completely, cutting the rubber seal off then hitting the bearing with a rift or chisel. If all else fails, ANGLE GRINDER.
With the shims, if you are replacing these bearings, they will be tighter than the old bearings. Try at least one shim top and bottom, you should be able to swivel the knuckle on the steering joint with no more than 2.5kg of force once you have the kingpin bearings tightened down (on top and bottom of the knuckle). Anymore and you could risk cracking the bearing when under extreme conditions.
(How do I upload photos directly to the forum??? pm! pls.)
Don't expect to see my recipe, until I receive my cheque and collection fee
Who is online
Users browsing this forum: No registered users and 0 guests