Going to replace my 80 series rear axle studs to 100 series
jobbies. I will be doing the mod myself.
I have two options with the collets:
1. Use the original collets and drill them out to 10mm therefore
the tapers in the axle flange need not be machined to suit the bigger
hunjy collets.
2. Use the hunjy collets which means I'll have to machine the axle flange
tapers
What is the preferred option (ie strongest) as i have seen both used
successfully.
Cheers
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
80 to 100 rear axle stud mod
Moderators: toaddog, Elmo, DUDELUX
if you have access to a lathe, drill the tapered part of the holes in the axle and make some bushes to suit the new hole and bolt size. no tapered collets anymore. Also we use allen bolts instead of studs for easy axle removal. i've had no problems at all (used to snap axle studs almost every time we went out).
Who is online
Users browsing this forum: No registered users and 0 guests