ive got a airesearch turbo im told its made by garret
its a bit stiff to spin,and has been sittin in a garage for a few years ,it was given to me so id like to rebuild it and put it on my cruiser
can anyone tell me where i can get a manual,or specs and a rebuild kit for this turbo,any help is appreciated
thanks
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
rebuilding a turbo
Moderators: toaddog, TWISTY, V8Patrol, Moderators
not sure if they do them, but this guy I will link you too rebuilds turbos for skylines/180s etc etc.... perhaps if you sent him a photo he could say "yeah that will cost..."
To high flow (total rebuild plus high flow) a skyline/180 turbo it's around $800
Note he uses journal bearings, not Ball bearing. Whether that is a problem or not is debatable...but the guys on that forum have had no probs with them. I know the same job through garret with a BB turbo is $1400...
http://www.skylinesaustralia.com/forums ... user=13726
To high flow (total rebuild plus high flow) a skyline/180 turbo it's around $800
Note he uses journal bearings, not Ball bearing. Whether that is a problem or not is debatable...but the guys on that forum have had no probs with them. I know the same job through garret with a BB turbo is $1400...
http://www.skylinesaustralia.com/forums ... user=13726
Who is online
Users browsing this forum: No registered users and 157 guests