Page 2 of 2
Posted: Wed Feb 17, 2010 4:53 pm
by bigredbarn
DX 80 wrote:Just for a giggle, price a genuine cv from toyota. Freaking exhorbatant. Somewhere around the $900 mark off memory.
if you look at spending that much might as well just go for a chromolly cv lot stonger from wat ive heard and only $650 each side from snake racing.
Posted: Thu Feb 18, 2010 9:31 am
by mada1234
FOUR DAYS FOR AN AXLE SHAFT,, IT MUST BA COMING VIA SEA WITH A BOATLOAD OF REFUGEES................ HURRY UP
Posted: Thu Feb 18, 2010 10:39 am
by mada1234
WELL DONE GUYS,, ORDER THE WRONG BLOODY PART FOR ME...
WHAT A SWITCHED ON CROWD YOU LOT ARE....
DO ANY OF YOU ACTUALLY DRIVE,LIVE,BREATHE TOYOTAS????
THE ANSWER IS NOW GLARINGLY BLOODY OBVIOUS TO ME NOW...
A BIG FAT NO!
Posted: Thu Feb 18, 2010 4:45 pm
by mada1234
LIKE, I KNOW YOU GET A DECENT WAGE FOR WORKING FOR TOYOTA FOR DOING N O T H I N G,, BUT SOME OF US WORK FOR A LIVING DAMMIT.... SMEGHEADS
Posted: Fri Feb 19, 2010 12:51 pm
by mada1234
OHHH HELLO THERE SIR,,, SORRY WE TOOK SO LONG TO ACTUALLY GET THE CORRECT PART,,, THEN BECAUSE WE TAKE SOOOO LONG TO GET THE JOB DONE, WE HAVE FOUND MORE PROBLEMS ......
AHHHHH THANKS A FUCKING LOT FOR LEAVING IT TILL I ACTUALLY RING YOU TO FIND THIS CRAP OUT,,, NOW ITS GOING TO COST YOU MORE MONEY, AWWW FOR FUCKS SAKE YOU PACK OF FREAKING USELESS SMEGHEADS....
Posted: Fri Feb 19, 2010 4:11 pm
by DX 80
THEN BECAUSE WE TAKE SOOOO LONG TO GET THE JOB DONE, WE HAVE FOUND MORE PROBLEMS ......
This was coming.
Posted: Sat Feb 20, 2010 12:26 pm
by mada1234
All i can say is thankfully it is all over, fixed, back in albury wodonga now... going to head out towards the underground miners hut near yackandandah for a bit of 4dw'ing...
Posted: Sat Feb 20, 2010 6:24 pm
by mada1234
PMSL.... JUST REALISED SOMEONE HAD TO "CORRECT MY GRAMMATICAL ERRORS" CHEERS,, THANKS, IT WAS NEVER MY STRONG POINT..........
Posted: Mon Feb 22, 2010 10:56 pm
by RaeNTroy
pulled apart front RH side and found my hub flange and hub had threaded themselves, so install a new cv, flange and hub and see how far we get!
Posted: Thu Feb 25, 2010 10:12 pm
by RaeNTroy
replaced CV joint AND flange, i have my drive back and now all is good!!!
