Outer Limits 4x4 Board

Very cool, that is a massive job u have started, hope it turn out well

How did u line up the 3rd member with the diff centre so the axles will be straight (both front to back and up and down), I imagine if it is the slightest bit out at the centre, it will be way out buy the time u reach the hubs. Have u got some special tools u are using, or jigs u have made up?

There is jigs, at this point though we stil have some play.

I have a 2m length of 45mm 4140 to use as an alignment bar to go the whole way though and have a modified 3rd member which also accepts this through where the bearings useually sit.

So whats happening? im keen for more pics

I got bearings and seals during the week.

This week should be a big week of building

Well with having a heap of stuff on lately I am finaly able to get back to this project.

Here is some machining bling.

1st: This is the seal retainer to stop the diff oil reaching out to the wheel bearings



2nd: Top view of the full float spindle



3rd: Side view of spindle



4th: Side view of B260 spindle vs a Toyota full float spindle



5th: Top view of B260 vs a Toyota spindle. Shows the difference between a 30 and 40 spline axle well



Spindle still needs the keyway

Looking Ace Bubs



Mock

to bling for scottys pile