Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

different pcd on zf spacer (HELP PLEASE)

Tech Talk for Rover owners.

Moderator: Micka

Forum rules
Post Reply
Posts: 289
Joined: Mon May 29, 2006 8:27 pm
Location: carrum downs

different pcd on zf spacer (HELP PLEASE)

Post by UrbanRedneck »

Hi there again i was ready to put my zf conversion in after pulling lt77 out and noticed that the pcd on the crank was different to that of the spacer for zf and that on the flywheel it has i think 6 bolt and the spacer only 4 what the hel is with that.

I also have another 3.5 under the bench and the crank is the same as the one in the car.

WHAT DO I DO??? HELP PLEASE!!!
Top
Posts: 111
Joined: Wed Jun 15, 2005 10:44 am
Location: yinnar south

Post by mopar rangie »

sounds like another spacer may have to be made up.with counter bored holes for some cap heads to hold it to the crank and some threads in it to take the flex plate.not to hard a job if ya know someone with a lathe and a drill.
smooth rides with power
Top
Posts: 16934
Joined: Sun Oct 20, 2002 6:57 pm

Post by RUFF »

There should be 2 seperate spacers with the ZF Auto. One bolts to the crank. Then the flex plate is fitted to this then the 4 bolt adapter is fitted over the flex plate then the drive plate goes on top of that.
Top
Posts: 289
Joined: Mon May 29, 2006 8:27 pm
Location: carrum downs

Post by UrbanRedneck »

RUFF wrote:There should be 2 seperate spacers with the ZF Auto. One bolts to the crank. Then the flex plate is fitted to this then the 4 bolt adapter is fitted over the flex plate then the drive plate goes on top of that.



Thanx Ruff would you know of anywhere i may be able to get hold of one today.

Spose i would be able to spin one up at work but dont know how thick it should be.
Top
Posts: 289
Joined: Mon May 29, 2006 8:27 pm
Location: carrum downs

Post by UrbanRedneck »

got one :armsup: :armsup: :armsup: :armsup:

Bloody pricey but for second hand $60

Thanx again for your help
Top
Post Reply

Return to “Rover”

Who is online

Users browsing this forum: No registered users and 4 guests