Quick dual case question

Post by **bubs** » Sat Dec 06, 2003 4:41 pm

what is the exact dimension between the centres of where the stock rubber mounts are on the t-case and the crawler box on a dual case setup

Post by **fabricator** » Wed Dec 10, 2003 1:32 pm

6.5 inches rings a bell, will know this weekend for sure, am installing another one.

Post by **POS** » Wed Dec 10, 2003 2:24 pm

I can tell you that when you put dual cases in you need to shorten the rear shaft by 165mm ( and vice versa for the front).

Post by **hypo** » Wed Dec 10, 2003 4:36 pm

o working on mine this arvo so ill measure up and get some pix and get back 2 u later 2nite

Post by **bubs** » Sun Dec 14, 2003 4:35 pm

hypolux wrote:o working on mine this arvo so ill measure up and get some pix and get back 2 u later 2nite

well?

Post by **hypo** » Sun Dec 14, 2003 8:34 pm

Post by **bubs** » Mon Dec 15, 2003 10:17 pm

anyone

Post by **POS** » Mon Dec 15, 2003 10:43 pm

POS wrote:I can tell you that when you put dual cases in you need to shorten the rear shaft by 165mm ( and vice versa for the front).

Can you not WORK it out using this measurement??????

Post by **bubs** » Mon Dec 15, 2003 11:03 pm

sorry about the other reply :oops:

i have reserched on pirate and a few other places and it says 6.5" which equals 165.1mm

so i hope if i make it to this it should fit

Website · Post by **killalux** » Tue Dec 16, 2003 6:11 pm

so how long do u think untill these will be ready, i will test it for you :lol:

Post by **toy283** » Wed Dec 17, 2003 2:44 pm

6½" exactly. That's what mine is.

Post by **bubs** » Wed Dec 17, 2003 2:45 pm

toy283 wrote:6½" exactly. That's what mine is.

thanks

Outer Limits 4x4 Board