Outer Limits 4x4 Board

Posted: **Sat Dec 06, 2003 4:41 pm**

what is the exact dimension between the centres of where the stock rubber mounts are on the t-case and the crawler box on a dual case setup

Posted: **Wed Dec 10, 2003 1:32 pm**

6.5 inches rings a bell, will know this weekend for sure, am installing another one.

Posted: **Wed Dec 10, 2003 2:24 pm**

I can tell you that when you put dual cases in you need to shorten the rear shaft by 165mm ( and vice versa for the front).

Posted: **Wed Dec 10, 2003 4:36 pm**

o working on mine this arvo so ill measure up and get some pix and get back 2 u later 2nite

Posted: **Sun Dec 14, 2003 4:35 pm**

hypolux wrote:o working on mine this arvo so ill measure up and get some pix and get back 2 u later 2nite

well?

Posted: **Sun Dec 14, 2003 8:34 pm**

Posted: **Mon Dec 15, 2003 10:17 pm**

anyone

Posted: **Mon Dec 15, 2003 10:43 pm**

POS wrote:I can tell you that when you put dual cases in you need to shorten the rear shaft by 165mm ( and vice versa for the front).

Can you not WORK it out using this measurement??????

Posted: **Mon Dec 15, 2003 11:03 pm**

sorry about the other reply :oops:

i have reserched on pirate and a few other places and it says 6.5" which equals 165.1mm

so i hope if i make it to this it should fit

Posted: **Tue Dec 16, 2003 6:11 pm**

so how long do u think untill these will be ready, i will test it for you :lol:

Posted: **Wed Dec 17, 2003 2:44 pm**

6½" exactly. That's what mine is.

Posted: **Wed Dec 17, 2003 2:45 pm**

toy283 wrote:6½" exactly. That's what mine is.

thanks

Quick dual case question