Page 1 of 1
80 series roll cage into 60 series
Posted: Sun May 13, 2007 9:06 am
by bj on roids
I have 2 full roll cages (CAMS) approved from GXL 80 series' one is steel and one is alloy.
I was wondering if I could fit these into the body shell of a 60 series?
anybody know?
Posted: Tue May 15, 2007 5:28 pm
by balzackracing
I know this is not your answer but I did'nt think CAMS approved aluminium roll cage's any more. Mate of mine has build a few HQ racers and they will not allow any aluminum cage's unless they were approved prior to that ruling.
mmm
Posted: Tue May 15, 2007 7:52 pm
by Brad
No you can't, unless they were a real bad fit in an 80 series.
The roof profile of teh 60 and the 80 are totally different along with the floor profile.
I am not saying you couldn't make it fit but it will not bolt in.
As for CAMS approval, a cage can't have it. The cage can be manufactured to cams specs but cams approval requires it to be installed correctly and a log book entry made.
If the cage is not installed in a vehicle it could have a compliance cert but to have approval it would need to be fitted and inspected.
Posted: Sat May 19, 2007 6:24 am
by bj on roids
were approved when fitted the alloy one is over 10 years old. been sitting around a while.