Page 1 of 1

What is this supposed to be connected to?? (TD42)

Posted: Mon Dec 31, 2007 2:25 pm
by coxy321
Hi all. While checking everything over again under the bonnet of my TD42 GQ1, i noticed a small diaphragm looking jigger mounted under the main airbox on the drivers side. Its a smallish cylinder, half black plastic and half clear plastic, with a pressure spring visible inside. The reason i noticed it was because i picked out the bit of brocken hose hanging off the back of it.

I had a scout around the engine bay, and also tracked the small vacuum line up to the A/C throttle advance diaphragm, where i also found a T-piece on the vacuum pump side, with one of the outlets just plugged with a bolt. I'm guessing that maybe this is what "should" be connected to the little cylinder under the air box.

Any help much appreciated!!!

Cheers - Coxy

Posted: Mon Dec 31, 2007 5:01 pm
by Dak
Sound's like an aircleaner indicator, a red piece shows in the clear part when the filter is dirty and clogged, I've never seen one on a TD42, at least not from the factory.

Cheers, Jeff.

Posted: Mon Dec 31, 2007 5:23 pm
by lolergram
If you are still stuck, post up some pictures....

Posted: Mon Dec 31, 2007 6:25 pm
by Adam GQ
Sound's like an aircleaner indicator, a red piece shows in the clear part when the filter is dirty and clogged, I've never seen one on a TD42, at least not from the factory.

i have and thats exactly what it is

Posted: Tue Jan 01, 2008 11:00 am
by Yom
Yeh mine has one of them.

Posted: Wed Jan 02, 2008 8:29 am
by coxy321
Ahah! Its so obvious now! Thanks guys.

So what is the line of the back of it supposed to hook up to?

Cheers!

Posted: Sun Jan 06, 2008 8:11 pm
by turps
There is a dirty filter light on the dash. Mates ute used to be able to get it to come on all the time with the turbo.

Posted: Mon Jan 07, 2008 10:08 am
by coxy321
So there must be a vacuum sensor somewhere to trigger the warning light. Could any of you guys poke your head under the bonnet for me and check to see where the black hose off the back of the dirty filter diaphragm goes to??? I dont want to leave it open on the end like it is ATM so the dust and shit can get in there.

Cheers!!