pathfinder body lift??

[mashed_zook]

hey guys i have done quck search but to no avail..

the older 2 door pathys is it posible (and easy) to put a bl in them? just a 2 inch one?
or maby 3?

just looking at buying one nice and cheep figured might as well reserch before i comit any coin.

chears in advance.
Phil

[sw1]

sure is

bit time consuming & a bit fiddly but not hard

4 of the 10 bolts have a different tread pitch, much finer from memory
& extendable steering shaft usually rusted solid, so that can take a bit of effort

you will have to check legality on 3" body lifts - i think it use to be ok but not now. not sure tho.

also 3" you will need to tweak the transfercase selector. 2" i did not need to

dont forget you need to raise the front & rear bumpers/bars otherwise they will look real silly

[JOHNZ]

i sell bodylift kits for early pathfinder 2 inch.
Don't go 3 inch too many haedaches.
cheers

[mashed_zook]

johnz PM SENT

no worry's about bars i have a tube bender and im keen to get some practice in!!! already have some designs drawn up...

it is also on gas so will have to look where the lines run and that there not a PIA!!!