Page 1 of 1
pathfinder body lift??
Posted: Mon Jan 14, 2008 10:30 am
by mashed_zook
hey guys i have done quck search but to no avail..
the older 2 door pathys is it posible (and easy) to put a bl in them? just a 2 inch one?
or maby 3?
just looking at buying one nice and cheep figured might as well reserch before i comit any coin.
chears in advance.
Phil
Posted: Mon Jan 14, 2008 12:23 pm
by sw1
sure is
bit time consuming & a bit fiddly but not hard
4 of the 10 bolts have a different tread pitch, much finer from memory
& extendable steering shaft usually rusted solid, so that can take a bit of effort
you will have to check legality on 3" body lifts - i think it use to be ok but not now. not sure tho.
also 3" you will need to tweak the transfercase selector. 2" i did not need to
dont forget you need to raise the front & rear bumpers/bars otherwise they will look real silly
Posted: Mon Jan 14, 2008 12:56 pm
by JOHNZ
i sell bodylift kits for early pathfinder 2 inch.
Don't go 3 inch too many haedaches.
cheers
Posted: Mon Jan 14, 2008 2:03 pm
by mashed_zook
johnz PM SENT
no worry's about bars i have a tube bender and im keen to get some practice in!!! already have some designs drawn up...
it is also on gas so will have to look where the lines run and that there not a PIA!!!