Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Holden Distibutor Conversion....???

Tech Talk for Rover owners.

Moderator: Micka

Forum rules
Post Reply
Posts: 36
Joined: Sat Jul 14, 2007 7:37 pm
Location: Newcastle

Holden Distibutor Conversion....???

Post by 1tuff_disco »

Have just put a 4.6 in my disco and now running GM Delco computer and want to convert my distributor to the VR/VS/VT Distributor. Anyone go info, i know it can be done
Top
Posts: 177
Joined: Fri Dec 19, 2003 11:49 am
Location: Perth WA

Post by Lucus »

Very Simple job. Dizzy shaft and bodt need to be shortened and an o-ring groove cut into the lower shaft body. I have converted my 4.6 to coil packs and will removing the dizzy shortly so i will grab a couple of photos in the next few days

Pm me an email address and i'l send them too you.

cheers
Luke
Top
Posts: 36
Joined: Sat Jul 14, 2007 7:37 pm
Location: Newcastle

Post by 1tuff_disco »

Thanks mate. PM sent. Where did you get the machining done?
Top
Posts: 177
Joined: Fri Dec 19, 2003 11:49 am
Location: Perth WA

Post by Lucus »

Just a local engineering mob here in perth Any body who knows there toolstock from there feed slide could machine it :D
Top
Post Reply

Return to “Rover”

Who is online

Users browsing this forum: No registered users and 24 guests