Outer Limits 4x4 Board

Have just put a 4.6 in my disco and now running GM Delco computer and want to convert my distributor to the VR/VS/VT Distributor. Anyone go info, i know it can be done

Very Simple job. Dizzy shaft and bodt need to be shortened and an o-ring groove cut into the lower shaft body. I have converted my 4.6 to coil packs and will removing the dizzy shortly so i will grab a couple of photos in the next few days

Pm me an email address and i'l send them too you.

cheers
Luke

Thanks mate. PM sent. Where did you get the machining done?

Just a local engineering mob here in perth Any body who knows there toolstock from there feed slide could machine it