Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Brake pedal goes hard sometimes while driving.

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Post Reply
Posts: 1698
Joined: Sun Nov 28, 2004 7:26 pm
Location: Canberra Australia

Brake pedal goes hard sometimes while driving.

Post by Ezookiel »

If you pump a brake pedal without the ignition off, it gets hard to push and the brakes are very hard to operate.
That's happening to my vehicle while I'm driving it with the ignition still on.
I've parked it in my driveway and don't think it will be going anywhere until I know what's going on, and then to drive very carefully to a brake specialist, but before I get told a whole heap of lies there, it would be nice to have SOME idea of what it could possibly be.
Any ideas, it normally clears instantly, and mostly seems to happen when steering hard to either left or right such as turning into a parking spot.

Thanks in advance for any ideas so I'll know what I'm hearing when the brake specialist gives me his opinions.
[url=http://www.4x4him.org]Bringing the Christian Rock Crawling Community a little closer[/url]
Posts: 1256
Joined: Mon Jun 19, 2006 7:05 pm
Location: newzealand

Post by tweak'e »

vacuum leak on the booster. check hoses otherwise vacuum canister, pump or booster.

i assume of course when you say ignition still on you do have the motor running.
Posts: 3940
Joined: Wed Dec 27, 2006 1:09 pm
Location: Sunshine Coast Qld

Post by want33s »

With the engine OFF pump the brake pedal a few times and then hold it down,(this should use the vacuum in the booster) and then start the engine, if the pedal sinks a little upon startup your booster is working.
You don't say if it's petrol or diesel :roll:
If its a diesel then your vacuum pump may be faulty.
Posts: 2765
Joined: Wed Jan 14, 2004 10:32 pm
Location: somewhere out there

Post by shorty_f0rty »

you say its when you do hard turns, could you be pinching a brake line somewhere? something quick and easy to check?
Built, not bought!
'84 BJ42 - sold! :(
'79 Coiled and turbo diesel'd FJ55
Posts: 1931
Joined: Sun Jun 22, 2003 10:29 am
Location: Everything 4WD, 86 Camms Rd Cranbourne

Post by GUJohnno »

I had an issue on a high country tip just after Christmas.
Brake pedal would go hard and virtually no brakes.

Turned out that there is a one way valve that stops you loosing pressure in the system. This was positioned below the 2nd battery. The battery had been leaking and ate through the plastic and was loosing vacuum.
My club
www.vfwdc.com
My store
Everything 4WD
86 Camms Road Cranbourne
www.everything4wd.com.au
sales@everything4wd.com.au
Phone: 03 59955055
Posts: 1698
Joined: Sun Nov 28, 2004 7:26 pm
Location: Canberra Australia

Post by Ezookiel »

'89, 4.2 Diesel Patrol.
Thanks for the ideas of what it could be, might even save me a trip to a brake specialist if it's one of the things you've suggested.

Much appreciate the help.
[url=http://www.4x4him.org]Bringing the Christian Rock Crawling Community a little closer[/url]
God of Athiests
Posts: 8337
Joined: Thu Aug 07, 2003 2:14 am
Location: Brownsville

Post by DamTriton »

Ezookiel wrote:'89, 4.2 Diesel Patrol.
Thanks for the ideas of what it could be, might even save me a trip to a brake specialist if it's one of the things you've suggested.

Much appreciate the help.
Add a good look at the vacuum pump on the back of the alternator (not there on petrol models)
George Carlin, an American Comedian said; "Think of how stupid the average person is, and realise that half of them are stupider than that".
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests