Page 1 of 1
front axle inner shaft question
Posted: Fri Mar 14, 2008 8:31 pm
by giacomo.m
Hi all,
I am owner of Pajero 3.0 V6 1993 LHD Super select.and I have problems
to right hand inner shaft removal.
I have tried also with an sliding hammer to flange from differential carrier but without result.
you have some tricks ?
thank you
Giacomo
Posted: Sat Mar 15, 2008 5:32 am
by markyd
Hi i have the same problem, i am going to try again tomorrow to remove it via a slide hammer, if not i shall be changing the axle..any tips anyone please?
Posted: Sat Mar 15, 2008 7:20 am
by CapnCrunch
I'd say just keep at it. I've removed several from Gen I trucks using a slide hammer. Some come right out after only a couple hits with the slide hammer, others have taken lots of force and many hits. You should get it eventually.
Posted: Sat Mar 15, 2008 7:22 am
by markyd
thanks
Posted: Sat Mar 15, 2008 10:26 am
by glenn_c
My gen2 I just use the CV as a slide hammer not much force required
inner axle
Posted: Sat Mar 15, 2008 10:44 am
by klrevo
glenn_c wrote:My gen2 I just use the CV as a slide hammer not much force required
exactly what iv always done. Worked a treat every time, and like glenn said, not that much force needed. Dont have to worry about it anymore
dean
hi
Posted: Sat Mar 15, 2008 2:29 pm
by gen1swbute
with a slide hammer it will try to pull on a angle,and it wont come out at all !use the cv as doiong this it will pull it out straight then the cir clip will let go and all will be good .if u persist with the slide hammer u risk the chane of damage to uur diff centre.same as a front wheel drive .if u try leaver it out it wont come but if u use the cv it will .best of luck.