Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

front axle inner shaft question

Tech Talk for Mitsubishi owners.

Moderator: -Scott-

Forum rules
Post Reply
Posts: 68
Joined: Thu Sep 09, 2004 8:52 pm
Location: Italy

front axle inner shaft question

Post by giacomo.m »

Hi all,
I am owner of Pajero 3.0 V6 1993 LHD Super select.and I have problems
to right hand inner shaft removal.
I have tried also with an sliding hammer to flange from differential carrier but without result.
you have some tricks ?
thank you

Giacomo
Top
Posts: 7
Joined: Mon Sep 25, 2006 6:09 am

Post by markyd »

Hi i have the same problem, i am going to try again tomorrow to remove it via a slide hammer, if not i shall be changing the axle..any tips anyone please? :roll:
Top
Posts: 69
Joined: Thu Jul 26, 2007 12:55 pm
Location: Crawlorado, USA

Post by CapnCrunch »

I'd say just keep at it. I've removed several from Gen I trucks using a slide hammer. Some come right out after only a couple hits with the slide hammer, others have taken lots of force and many hits. You should get it eventually.
Joe
88 Montero (Pajero) 2.6L 5-speed - dual-locked, low-geared, armored, lifted, lit, rigged for dive... [img]http://www.fivethirty.com/images/blah.gif[/img]
Top
Posts: 7
Joined: Mon Sep 25, 2006 6:09 am

Post by markyd »

thanks :cool:
Top
Posts: 104
Joined: Wed Feb 16, 2005 2:32 pm
Location: Gold Coast

Post by glenn_c »

My gen2 I just use the CV as a slide hammer not much force required
Pajero GLX 2.8td 255/85/16 BFG muds 265/75/16 BFG AT's, articulator, 2.5inch lift, ball joint flip, rear sway bar disconnect and lots of mods.
Top
Posts: 1423
Joined: Thu May 26, 2005 7:00 pm
Location: Central Coast, NSW

inner axle

Post by klrevo »

glenn_c wrote:My gen2 I just use the CV as a slide hammer not much force required
exactly what iv always done. Worked a treat every time, and like glenn said, not that much force needed. Dont have to worry about it anymore :D

dean ;)
Top
Posts: 16
Joined: Wed Feb 13, 2008 4:02 pm
Location: ipswich

hi

Post by gen1swbute »

with a slide hammer it will try to pull on a angle,and it wont come out at all !use the cv as doiong this it will pull it out straight then the cir clip will let go and all will be good .if u persist with the slide hammer u risk the chane of damage to uur diff centre.same as a front wheel drive .if u try leaver it out it wont come but if u use the cv it will .best of luck.
Top
Post Reply

Return to “Mitsubishi”

Who is online

Users browsing this forum: No registered users and 17 guests