Outer Limits 4x4 Board

Posted: **Mon Mar 17, 2008 9:06 am**

Just wondering, on first glance a GQ uni looks larger then an 80.
but measured what we could without pulling the shafts apart and not having 2 unis out. they look very very similar.
can anyone confirm are they identical or different items just similar.

this is more of a fingers crossed thing. as i have now found out GQ tailshaft flange(rear) is too large to fit with re-drilling onto an 80 series diff flange.
and the design team feels it is too dodgy to run a larger plate as an adaptor with holes drilled in it to suit both flanges.
thoughts on this? in a low speed vehicle, just trying to get built for TTC in 24 days. then i can get a better custom shaft made with time and $$ on my side.

Posted: **Mon Mar 17, 2008 7:03 pm**

if the adaptor is done right it will be fine, I have know idea about the uni's sorry

Posted: **Mon Mar 17, 2008 7:04 pm**

Your design team sucks. Just make the adapter

Your not driving it to TTC are you.

Posted: **Mon Mar 17, 2008 7:13 pm**

a properly machined adaptor will be fine we make them all the time and no a nissan uni is larger than the 80 series uni 32mm cap against 30mm for the toyota

Posted: **Tue Mar 18, 2008 7:23 am**

cheers guys!

rock on!

thanks for the help. its all abit stressful with just over 3 weeks remaining!

Posted: **Tue Mar 18, 2008 2:17 pm**

Try a GQ 2.8 diesel shaft as the flange is smaller but from memory the uni is bigger ( i could be wrong on the uni).
But the bolt pattern and the flange at either end of the shaft is deffinetly smaller.

Posted: **Tue Mar 18, 2008 3:41 pm**

nottie wrote:Try a GQ 2.8 diesel shaft as the flange is smaller but from memory the uni is bigger ( i could be wrong on the uni).
But the bolt pattern and the flange at either end of the shaft is deffinetly smaller.

Hev has allready had custom shafts made. And didnt check that he could get it to fit before hand.

Posted: **Wed Mar 19, 2008 11:07 am**

Posted: **Thu Mar 20, 2008 8:51 am**

yeah was a slight oversight.
bloody redzook told me both ends would fit.

front lux shaft bolts right up.

rvh96, mayday?
has anyone got a ph number for ron? i would like to get him onto the adaptor asap.

Tony

Posted: **Thu Mar 20, 2008 11:31 am**

If you can get me the dimensions you need, i can cut one on the plasma today?

Layto....

Posted: **Thu Mar 20, 2008 5:03 pm**

DIRTY ROCK STAR wrote:yeah was a slight oversight.
bloody redzook told me both ends would fit.

front lux shaft bolts right up.

rvh96, mayday?
has anyone got a ph number for ron? i would like to get him onto the adaptor asap.

Tony

its like a 15 min job max

i have no idea how big that stuff is so if i did tell you that sucked in

Outer Limits 4x4 Board

80 Uni VS GQ Uni

80 Uni VS GQ Uni