Outer Limits 4x4 Board

what pressure should be in staun beadlocks?

Cheers,

Welchy

From the Staun site, 50 spi. http://www.staunproducts.com/ST7590%20page2.pdf

We have run ours at 40psi, with no problems. They must be higher than the tyre pressure, so if you put the tyre to 44psi you must set the staun above 44psi.

We normally max the tyre pressure at 30psi, so 40 psi in the staun is not a problem.

yep!! 2nd that!! mine also at 40psi,(& were fitted bt steve at staun)

I run mine at 45psi and tyres at anywhere between 8psi and 35psi. I was told to run then at 46psi by the ARB shop i got them from but 45psi is easier to read on the gauge!

I been told appox 4 psi higher than your onraod tyre pressure and must be between 35 and 45 psi.

Go with 45-50 PSI as stated by Staun in their website. I reckon they are the ones who DO know, rather than being "told" by anyone.

4-5 PSI above tyre pressure was the old and outdated recommendation given initially when I bought them as "Secondairs" but later changed on discussion with the old distributors (at 4WD shows etc). This was also the initial reason Secondairs got a bad rap as not working that well.

FWIW 45-50 psi for the last 5 4 1/2 yrs without issue. Hve aired down to 8 psi at times but generally use 14-16 psi in a 1700kg vehicle with 31 x 10.5R15 tyres

my stauns stay at 40 plus, rear tyres in in comps on mine are usually 8 to 12psi, & fronts are at 12 to 16 psi,in 37" M/T claws,,touch wood ive never had one slip...there worth every $$$$$

I run my tyres at 20psi max and 3.5psi min... stauns at 50psi all the time.