Page 1 of 1
4.2td into a petrol LWB GQ chassis?
Posted: Wed Feb 25, 2004 10:36 am
by pete's GQ
My main queston is. can a 4.2 diesel go straight into a petrol GQ ie. is the wiring harness the same for all GQ's or do i need to change the harness. as far as all the accessories go i have a complete gq 4.2td with bent chassis rails hence the swap, much cheaper to by a tidy st or ti than repair and get a better spec 4wd in the proccess,
Any ideas would be appreciated, and if any one see, a good gq lwb 1994 onward that is dead straight and in perfect nick inside and out drop me a PM.
cheers and prior thanks
Pete
Posted: Wed Feb 25, 2004 11:41 am
by Woop
I THINK the wiring harness is a bit different to accomodate things liike the glow plug timer and glowplugs etc. The glowplug timer is in the drivers side kick panel just below the fuses. Check and see if there's a multipin connector there taped up. Dont confuse it with the AUTO trans kickdown connector. Also the Alternator is on the right hand side for the petrol vs left hand for diesel. It should be possible, with a bit of dismantling to remove the petrol harness and swap it for a diesel.
NickW
Posted: Wed Feb 25, 2004 11:53 am
by Snatchy
Posted: Wed Feb 25, 2004 12:25 pm
by swbpatrol
i done the same swap for my shorty a few months ago and if you have the 2 vechiles in front of you you will be fine. I swapped the harness for a diesel one. Any more info needed just ask. It is a very simple swap and the rewards are endless, best move i made
Posted: Thu Feb 26, 2004 12:45 pm
by bazzle
Dash boards and fuel lines different too
Bazzle