As I understand it I could shift it a few degrees and lower it by maybe 1500rpm
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
1.6 16V camshafts
1.6 16V camshafts
Any experience out there with degreeing the camshaft with an offset key or vernier gears to shift the torque delivery for better lower rpm performance? To reprofile it is too expensive as it will need welding before a grind due to the rocker setup As I understand it I could shift it a few degrees and lower it by maybe 1500rpm
As I understand it I could shift it a few degrees and lower it by maybe 1500rpm
Re: 1.6 16V camshafts
cj wrote:Any experience out there with degreeing the camshaft with an offset key or vernier gears to shift the torque delivery for better lower rpm performance? To reprofile it is too expensive as it will need welding before a grind due to the rocker setup
1500RPM? Are you talking about PEAK torque? You might have to re-align your expectations if you're thinking a vernier pulley is going to bring your peak torque in at 1500RPM. Should be able to lower it somewhat, not that far though.
Re: 1.6 16V camshafts
Damo wrote:cj wrote:Any experience out there with degreeing the camshaft with an offset key or vernier gears to shift the torque delivery for better lower rpm performance? To reprofile it is too expensive as it will need welding before a grind due to the rocker setup
1500RPM? Are you talking about PEAK torque? You might have to re-align your expectations if you're thinking a vernier pulley is going to bring your peak torque in at 1500RPM. Should be able to lower it somewhat, not that far though.
I belive that CJ meant that he could lower the engine revs by 1500rpm for the peak torque .. or to put it another way ... torque peak is now at 3500rpm instead of 5000rpm .. (thats how I read it) I reckon that around 900 rpm would be more realistic though ..
" If governments are involved in the covering up the knowledge of aliens, Then they are doing a much better job of it than they do of everything else "
Yeah, I meant that the peak torque would come in 1500 rpm lower. I have been given different degrees to alter it by and the amount of difference it may make. As the zook is a revy peaky kind of engine I thought it might be kinda nice to lower the point where max torque is developed and or to spread the torque band. Not worried about max highway speed just looking for improvements for smooth driveability offroad. Was also looking at some tri-Y headers and exhaust sytem improvements as well as an air filter change.
Who is online
Users browsing this forum: No registered users and 2 guests