Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Driveline spacers??

Tech Talk for Suzuki owners.

Moderators: lay80n, sierrajim

Forum rules
Post Reply
Posts: 148
Joined: Wed Apr 23, 2008 5:26 pm
Location: Narangba

Driveline spacers??

Post by meads02 »

I am currently changing my springs on my 91 WT to RUF and Mazda 323 rears. Will I need driveline spacers front and rear? I know there are plenty of threads about these mods, i'm just not sure about spacers. Cheers Dan
Top
Posts: 1791
Joined: Fri Aug 24, 2007 3:02 pm
Location: Kurrajong Heights, NSW

Post by BlueSuzy »

Where are you putting the diffs?

Front..
Standard location in front on rears u may need one. If you redrill back to stock position with stock fronts,You probably wont need one.

Rear.. you will need to redrill anyway. need more info
I am Tim
Top
Posts: 148
Joined: Wed Apr 23, 2008 5:26 pm
Location: Narangba

Post by meads02 »

Rear diff is an inch further back, front diff will be an inch forward.
Top
Posts: 2199
Joined: Sat May 01, 2004 4:59 pm
Location: dandenong vic

Contact:
Contact built4thrashing

Post by built4thrashing »

if it was me id do spacers in both.
1999 SQ625 Manual Grand Vitara. Lifted, Twin Locked, 31' Extremes, dual Batteries, Winch.
Lots of custom gear as I cant afford the proper stuff.
Top
Posts: 2600
Joined: Thu Sep 27, 2007 2:40 pm
Location: Townsville

Post by GRPABT1 »

I moved my front diff and inch forward recently and the shaft only just falls out when jacked up with the front tyres off the ground. I already have a 1 inch spacer to compensate for the lift but I will be putting another 3/4inch spacer in. Do the spring swap first then flex it to the bump stops on the pumpkin side and then disconnect your driveshaft from the diff and see how much you can push the spline of the shaft towards the transfer. If there is an inch room then use a 3/4inch spacer.
Build Thread - http://www.outerlimits4x4.com/viewtopic.php?f=16&t=168546&p=1927514&hilit=GRPABT1%27s+zook#p1927514
Top
Posts: 148
Joined: Wed Apr 23, 2008 5:26 pm
Location: Narangba

Post by meads02 »

ok i'll hopefully get it all finished tomorrow arvo and i'll test it out, thanks heaps for the help
Top
Post Reply

Return to “Suzuki”

Who is online

Users browsing this forum: No registered users and 0 guests